How To Install Tpms Service Kit
Huf TPMS Valve and Sensor Installation Instructions
A) Self-locking (Torx) mounting screw
B) Wheel electronic unit (sensor)
C) Valve with shoulder seal
D) Spacer ring
E) Collar nut
F) Valve cap
G) Mounting Pin
one) Push valve (C) with cycle electronic unit (B) screwed on through valve pigsty of the rim. Put spacer ring (D) in place and screw collar nut (E) until contact.
2) Put the instaation pin into the radial tedious of the valve and tighten collar nut with 4Nm (� 0.five) torque.
Attention: Remove installation pin again immediately, otherwise, the tire will be damaged during further installation.
3) Afterwards removal of the installation pin, press the wheel electronic unit of measurement lightly into the deep well of the rim. Now tighten self-locking (Torx) mounting screw with 4 Nm(� 0.5) torque.
four) The wheel electronic unit must now lie flat in the drib middle.
5) Now clamp the bike onto the installation machine (in such a style that the installation caput is located on the side opposite from the valve, meaning offset by 180 degrees. Rub soapy water onto the tire dewdrop and rim lip. Now, slide the lower dewdrop of the tire partly over the rim lip. Arrange the installation head on the rim lip and pull the lower tire dewdrop onto the rim.
ATTENTION: During installation, attention must be paid to ensure that the tire bead does not press once again the wheel electronic unit.
6) Subsequently the lower tire bead, pull the upper tire bead onto the rim as well. The valve must likewise be located on the reverse side of the installation caput (beginning past 180 degrees). So remove the complete cycle from the tire mounting unit. Increment tire pressure level without valve insert step-by-step to maximum 43.5 PSI (spring pressure level - until tire bead slides uniformly over the safety shoulders). Now, screw new valve insert into place and fill tire to prescribed air pressure. Put valve cap in place and balance bicycle.
7) Mountain complete wheels onto the vehicle.
viii) New initialization/calibration of the Huf TPMS sensor is necessary when:
- The tire pressure has been changed
- The spare bike has been mounted as a running wheel
- A new TPMS unit has been installed
- The control unit of measurement has been replaced
How To Install Tpms Service Kit,
Source: https://www.tpmsdirect.com/Huf_TPMS_Sensor_Installation_Procedures_a/804.htm
Posted by: hillmands1954.blogspot.com
0 Response to "How To Install Tpms Service Kit"
Post a Comment